Intel SBXD62 - Server Compute Blade, Installation And User Manual

Page: 29 / 118

Intel® Server Compute Blade SBXD62 Installation and User’s Guide 19
Removing the Blade Server Bezel Assembly
To install certain options, you must first remove the blade server bezel assembly. The
following illustration shows how to remove the bezel assembly.
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page 65 in Appendix C, “Safety
Information” and “Installation Guidelines” on page 15 .
2. Open the blade server cover (see “Opening the Blade Server Cover” on page 18 for
instructions).
3. Press the bezel-assembly release and pull the bezel assembly away from the blade
server approximately 1.2 cm (0.5 inch).
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Installing a SAS Hard Disk Drive
The blade server has two connectors on the system board for installing optional SFF SAS
hard disk drives.
Each SAS connector is on the same bus. Depending on the blade server model, at least one
SAS hard disk drive might already be installed. If the blade server is equipped with one
SAS hard disk drive, you can install an additional SAS hard disk drive. These two SAS
hard disk drives can be used to implement and manage a redundant array of independent
disks (RAID) level-1. See
“Configuring a SCSI RAID Array” on page 42 for information
about SCSI RAID configuration.
Control panel
connector
Bezel-assembly
release
Bezel-assembly
release
Control-panel
cable AF000438