Intel MB440LX, System Installation Manual

Page: 136 / 232

136
Chapter 5 SCSI Backplane and Drives: Hot-swapping and Configuring
Installing a SCSI SCA Hard Disk Drive in a Hot-docking Bay
See Figure 5-2.
1. Open the plastic front door.
2. If you installed a padlock on the metal door to the hot-docking bays,
unlock the padlock and remove it.
3. Loosen the two spring-loaded, captive screws that secure the metal
door to the chassis, and open the door.
4. Position the plastic carrier, locking tab up, and drive assembly so it
engages the hot-docking bay guide rails.
5. Gently push the drive into the bay until it docks with the backplane
connector and snaps into place.
6. Gently close the metal door, and secure it to the chassis with the two
captive screws.
7. For security and to prevent unauthorized access to the bays, insert a
padlock through the metal door and chassis and lock it.
8. Close the lower plastic front door.
9. If you installed an RPX board in the system, run the Disk Array
Controller Configuration utility supplied with the board. See the
documentation provided with the board.