2.5
Processor Removal
WARNING:
Processor heat sinks can become extremely hot during normal system operation. Before
attempting to remove the processor from the server board, ensure system power has been fully
disconnected and allow the processor heat sinks to fully cool before attempting to remove the PHM from
the server board.
1.
Using a T30 Torx bit screwdriver, loosen each heat sink nut in the sequence shown on the label
affixed to the top side of the heat sink (#4→ #3 → #2→ #1) (See letter
A
). Loosen each screw all the
way prior to moving to the next.
2.
Lift the PHM straight up from the server board until free from the bolster plate guide pins (See letter
B
).
3.
Figure 28. Uninstalling the PHM
4.
If a processor is not being installed, re-install the plastic processor socket cover.
Figure 29. Plastic processor socket cover Installation
