Intek HT-446S, Instruction Manual

Page: 6 / 40

Preliminary Steps
- 4 -
Battery charging
Connect the 230VAC adaptor charger to the desk type battery charger
and to a 230VAC outlet. The Red Led will flash to confirm that the charger
is powered.
Insert the empty battery or the transceiver with the battery pack in the
battery charger. Please make sure that the charging contacts of the radio
are connected with the charging contacts of the charger cradle. The Red
Led will light then the device is ready to begin the charging process. The
charging time depends on the battery condition and capacity. When the
charging process has finished, the Led lights in Green color. Remove the
battery pack or the transceiver from the battery charger and disconnect it
from the AC outlet.
Warning !
The battery is supplied empty and it has to be fully recharged before use.
Some complete cycles of charge/discharge will be necessary in order for the battery to reach a
peak efficiency level.
Please do not charge the battery again when it has just been charged. Otherwise, you may
damage the battery or reduce its life.
The battery charger does not switch OFF automatically when charging is complete, therefore
please remove battery or radio from the charger cradle and disconnect it from the AC outlet.
Do not recharge battery for more than 8 hours, in order to avoid battery overheating.
To install the battery
Place the battery pack on the radio as showed in the drawing (item 1).
Push the battery pack forward (item 2) until it is locked on the radio
(item 3).
1
2
3
English