D.
SUBWOOFER
21
81. SET AUX INPUT LEVELS
If you use any device (mp3 player, sat radio receiver, etc) that uses
a headphone out jack as input to the AUX IN, set the volume on
that device to approx. 80-90% of full volume. Adjust the AUX IN
level setting in the headunit to around 60-80% of full volume.
From the music control section in the headunit, select TONE ->
VOLUME SETTINGS -> AUX INPUT LEVEL and set the level.
82. CONFIRM SPEAKER CONNECTIONS & SETTINGS
In the headunit, turn the Balance control to fade full Left. Start-
ing with a 20Hz tone, play each higher frequency up to about
4kHz. You should hear only the subwoofer first, then at ~50Hz
you’ll transition to the underseat woofer, at ~150Hz to the mid-
range, and the tweeter at ~2.5kHz. You should hear each speaker
on the left, in the correct order. You may get some sound from
the right, but it should be low level. Fade Balance full Right and
repeat the process. When complete, center Balance & Fade.
83. ROCK. AND ROLL.
Reinstall any remainingtrim panels, seats, etc, in the reverse
order they were removed.
That’s it! You should be ready to rock and roll. If you aren’t
seriously impressed by the sound, something is wrong. Trust us
on this. It should be clean, clear, and balanced. If it isn’t, revisit
the steps above or reach out to us for support at 646-926-0011 or
email us at [email protected].
Verify that each speaker is
playing correctly.
