Advanced Operations
En-83
Zone 2 Video Output
By connecting the TV used in Zone 2 and the
HDBaseT(TM)
port on the AV receiver with
TIA/EIA568B (both ends) and CAT5e (or higher
category) compatible straight cable, you can enjoy
the audio and video via HDMI on the TV in Zone 2 at
most 100 meters away from the AV receiver.
Tip
• Connect the AV receiver to your TV using an HDBaseT™-
enabled device. Refer to your devices’ instruction manual
for details.
• If you use
HDBaseT(TM)
in Zone 2, make sure to set
“
Zone 2 Monitor Out
” to “
HDBaseT(TM)
” (
➔
page 60
).
• Video and audio signals from an HDMI input will be output
to
HDBaseT(TM)
.
• The information of connected component appears on a TV
in Zone 2 by pressing
Display
.
See “Multi Zone” (
➔
page 77
).
■
Operating on the AV receiver
Tip
• The Whole House Mode function shares the input source of
main room with Multi Zone (
➔
page 52
).
■
Operating on the remote controller
To control Zone 2/3, you must press
Zone
on the
remote controller first.
Zone
turns red when Zone 2 is on, and green when
Zone 3 is on.
Adjusting the Volume for Zones
■
Operating on the remote controller
■
Operating on the AV receiver
If your Zone 2/3 speakers are connected to a receiver
or integrated amplifier in Zone 2/3, use its volume
control to adjust the volume.
Setting the Zone 2/3 Out
Controlling Multi Zone Components
Input selector buttons
Zone 2
,
Off
Zone 3
,
Off
Tone
Master Volume
–
,
+
1
To turn on Zone 2/3 and select an input source,
press Zone 2 or Zone 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the
Z2
or
Z3
indicator lights on
the AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press
Zone 2
or
Zone 3
and
the
Tuner
input selector repeatedly.
To select the same source as the main room’s,
press
Zone 2
or
Zone 3
twice. “
Zone 2 Selector:
Source
” or “
Zone 3 Selector: Source
” appears
on the AV receiver’s display.
2
To turn off Zone 2/3, press Off for each Zone.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
8
Receiver
Muting
VOL
q
/
w
Zone
Input selector buttons
1
Press Zone repeatedly, then point the remote
controller at the AV receiver and press
8
Receiver.
Zone 2/3 turns on, the
Z2
or
Z3
indicator lights on
the AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press
Zone repeatedly, followed by an Input Selector
button.
To select AM or FM, press
Zone
and the
Tuner
input selector repeatedly.
3
To turn off Zone 2/3, press Zone repeatedly,
followed by
8
Receiver.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
1
Press Zone repeatedly.
2
Use VOL
q
/
w
.
1
Press Zone 2 or Zone 3 (the Z2/Z3 indicator on
the AV receiver’s display flashes).
2
Use Master Volume control within 8 seconds.