Integra DHC-80.2, Instruction Manual

Page: 70 / 116

70
En
Audio Selector
You can set priorities of audio output when there are both
digital and analog inputs.
■
Audio Selector
`
ARC :
The audio signal from your TV tuner can be sent to
the
HDMI OUT MAIN of the AV controller.
*1
With this selection the TV’s audio can be automati-
cally selected as a priority among other assignments.
`
HDMI :
This can be selected when HDMI IN has been
assigned as an input source. If both HDMI ( HDMI
IN ) and digital audio inputs ( COAXIAL IN or OPTI-
CAL IN ) have been assigned, HDMI input is auto-
matically selected as a priority.
`
COAX :
This can be selected when COAXIAL IN has been
assigned as an input source. If both coaxial and
HDMI inputs have been assigned, coaxial input is
automatically selected as a priority.
`
OPT :
This can be selected when
OPTICAL IN
has been
assigned as an input source. If both optical and
HDMI inputs have been assigned, optical input is
automatically selected as a priority.
`
Multich :
The AV controller always outputs analog signals
from multichannel analog input.
`
Balance :
The AV controller always outputs analog signals
from balanced input.
`
Analog :
The AV controller always outputs analog signals.
Note
• The setting is stored individually for each input selector.
• This setting can be made only for the input source that is
assigned as HDMI IN , COAXIAL IN , or OPTICAL IN .
• To select the digital audio input, see “Digital Audio Input” for
more detail (
➔
53 ).
• To select “ Multich ”, you must assign the multichannel input
(
➔
53
).
• To select “ Balance ”, you must assign the balanced input (
➔
53 ).
*1 You can select “ ARC ” if you select the TV/CD input selector.
But you cannot select it if you’ve selected “ Off ” in the “ Audio
Return Channel ” setting (
➔
66 ).
Setting the Incoming Digital Signal (Fixed
Mode)
By pressing Enter while selecting “ HDMI ”, “ COAX ”,
“ OPT ” in the “ Audio Selector ”, you can specify the input
signal in the Fixed Mode. Pressing Enter again allows
you to return to the “ Audio Selector ” setting.
Normally, the AV controller detects the signal format
automatically. However, if you experience either of the
following issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS.
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing a
DTS CD, try setting the format to DTS.
■
Fixed Mode
`
Auto :
The format is detected automatically. If no digital
input signal is present, the corresponding analog
input is used instead.
`
PCM :
Only 2-channel PCM format input signals will be
heard. If the input signal is not PCM, the
PCM indi-
cator will flash and noise may also be produced.
`
DTS :
Only DTS (but not DTS-HD) format input signals
will be heard. If the input signal is not DTS, the
DTS
indicator will flash and there will be no sound.
Note
• The setting is stored individually for each input selector.
• The setting will be reset to “
Auto ” when you change the setting
in the “ Audio Selector ”.