26
En
Basic Operations
You can determine the language used for the onscreen
setup menus. See “Language” in the “OSD Setup”
(
➔
65
).
■
Operating on the AV controller
■
Operating with the remote controller
You can display various information about the current
input source as follows. (Components connected to the
UNIVERSAL PORT
jack are excluded.)
Tip
• Alternatively, you can use the AV controller’s
Display
.
The following information can typically be displayed.
*1
The input source is displayed with the default name even
when you have entered a custom name in “Name Edit”
(
➔
61
).
*2
If the input signal is analog, no format information is dis-
played. If the input signal is PCM, the sampling frequency is
displayed. If the input signal is digital but not PCM, the signal
format and the number of channels is displayed. For some dig-
ital input signals, including multichannel PCM, the signal for-
mat, number of channels, and sampling frequency is
displayed.
Information is displayed for about three seconds, then the pre-
viously displayed information reappears.
You can adjust the brightness of the AV controller’s dis-
play.
Tip
•
(North American models)
Alternatively, you can use the AV
controller’s
Dimmer
.
This manual describes the procedure using the
remote controller unless otherwise specified.
Selecting the Language Used for the
Onscreen Setup Menus
Playing the Connected Component
1
Use the input selector buttons to select the input
source.
2
Start playback on the source component.
See also:
• “Controlling Other Components” (
➔
92
)
• “Controlling iPod” (
➔
87
)
• “Listening to the Radio” (
➔
32
)
3
To adjust the volume, use the
Master Volume
control.
4
Select a listening mode and enjoy!
See also:
• “Using the Listening Modes” (
➔
42
)
• “Audyssey” (
➔
59
)
1
Press
Receiver
followed by
Input Selector
.
2
Start playback on the source component.
See also:
• “Controlling Other Components” (
➔
92
)
• “Controlling iPod” (
➔
87
)
• “Listening to the Radio” (
➔
32
)
3
To adjust the volume, use
VOL
q
/
w
.
4
Select a listening mode and enjoy!
See also:
• “Using the Listening Modes” (
➔
42
)
• “Audyssey” (
➔
59
)
Displaying Source Information
Press
Receiver
followed by
Display
repeatedly to
cycle through the available information.
Setting the Display Brightness
Press
Receiver
followed by
Dimmer
repeatedly
to select: dim, dimmer, or normal brightness.
Sampling
frequency
Input source
Signal format
*2
Input signal
resolution
Output
resolution
Listening
mode
*1
Summary of Contents for DHC-80.2
Page 1: ...AV Controller DHC 80 2 Instruction Manual...
Page 114: ...114 En Memo...
Page 115: ...115 En Memo...
