29
Interconnections
Product Support:
e. Tighten each clamp bolt (or nut for 2000KPX frames) until it makes complete contact with the
piston.
f.
For 2000KPX frames: Tighten the setscrew of each clamp nut (use 6 mm hex key) (see
).
g. Clamp the crosshead lock cylinders.
h. Install the provided covers over the lock cylinders, refer to
“Install covers for crosshead lock
cylinders - J3-style crosshead”
.
6. Perform the “System Startup” procedure provided in Chapter 3 of the Operating Instructions that
were supplied with the system.
7. Check that the frame is enabled. If the frame will not enable, see
specifically
of the table. Once any problems are corrected, enable the frame.
Figure 12. Identifying the clamp bolts on frames with a J3-style crosshead.
Clamp bolt
(one for each lock cylinder)
Clamp nut
2000KPX-J3 Frames
All Frames Except
2000KPX-J3 Frames
Cover
Clamp bolt
(one for each lock cylinder)
Lock cylinder
Clamp bolt
or Clamp nut
(depending on frame
model)
Piston
Setscrew
(one per lock cylinder)
