LampLinc Owner’s Manual
CONTROLLING LAMPLINC FROM AN INSTEON CONTROLLER
Linking an INSTEON Controller to LampLinc
To use LampLinc as an INSTEON Responder, follow these steps to Link LampLinc and a Controller
together. Refer to the Controller’s Owner’s Manual for detailed instructions on how to properly install and
Link it to LampLinc.
The following will work for the most common INSTEON devices:
1)
Set the Controller to Linking Mode. (For most Controllers, press & hold an On or Scene button for 10
seconds or the Set button for 3 seconds.)
You will have 4 minutes to complete the next step before Linking Mode automatically times out.
2)
Press & hold the Set button on LampLinc for 3 seconds
The LampLinc Status LED should flash twice and then turn on solid
The load should flash twice
3)
Confirm that Linking was successful by pressing the button you just Linked to on the Controller
LampLinc should respond appropriately
Unlinking LampLinc from an INSTEON Controller
If you are going to discontinue using LampLinc, it is very important that you Unlink it from any Linked
Controllers. Otherwise, the Controllers will retry any commands repetitively, thus slowing down the
system.
The following will work for the most common INSTEON devices:
1) Set the Controller to Unlinking Mode. (For most Controllers, press & hold an On or Scene button for
10 seconds
twice
or the Set button for 3 seconds
twice
.)
You will have 4 minutes to complete the next step before Unlinking Mode automatically times out.
2) Press & hold the Set button on LampLinc for 3 seconds
The LampLinc Status LED should flash twice and then turn on solid
The load should flash twice
3) Confirm that Unlinking was successful by tapping the button you just Unlinked from on the Controller
LampLinc should no long respond
ON-LEVELS AND RAMP RATES
The
On-Level
is the brightness that the load will go to when you turn it on. The On-Level is adjustable
from off to 100% brightness. The default is 100%.
The
Ramp Rate
is the amount of time it will take the load to go from full-off to full-on or from full-on to full-
off. The Ramp Rate is adjustable from 0.1 to 9 seconds to ramp between full-on and full-off and vice
versa. The default is 0.1 seconds.
You can set up
remote
On-Levels/Ramp Rates that are activated when you tap an On/Off or Scene
button on a Linked Controller. A single LampLinc is capable of storing different On-Levels and Ramp
Rates for each Linked Controller (or each button if it is a multi-scene Controller).
On-Levels and Ramp Rates are locked in separately and can be set up in any order. When you do the
lock-in, the most recently set On-Level and Ramp Rate are locked in together.
Page 6 of 14
