LampLinc Owner’s Manual
ADVANCED X10 PROGRAMMING OPTIONS
Remotely Setting the On-Level for the X10 Primary Address
1) Using an X10 controller, send the CLEAR sequence:
O16
N16
M16
P16
M16
2) Send the X10 Primary Address (house code and unit code)
3) Use the buttons on a Linked Controller to adjust the load to the desired brightness level. If you skip
this step, the current On-Level will be used.
4) Send the following X10 address sequence to lock in the new On-Level:
P16
N16
M16
O16
M16
Remotely Setting the Ramp Rate for the X10 Primary Address
NOTE: If you use this method for setting the Ramp Rate, you can achieve Ramp Rates ranging from 0.1
seconds to ~8 minutes, 30 seconds (versus 0.1 to 9 seconds).
1) Using an X10 controller, send the CLEAR sequence:
O16
N16
M16
P16
M16
2) Send the X10 Primary Address (house code and unit code)
3) Use the buttons on a Linked Controller to adjust the load to the desired Ramp Rate (brighter is faster,
dimmer is slower). The following table gives the approximate relationship between the brightness you
set in this step and the Ramp Rate you get:
Approximate
Brightness Level
Ramp Rate
in seconds
90-100%
0.1
77-87%
0.2
65-74%
0.3
52-61%
0.5
39-48%
2.0
26.35%
4.5
13-23%
6.5
1-10%
8.5
Less than 1%
9.0
4) Send the following x10 address sequence to lock in the new Ramp Rate:
O16
P16
N16
M16
O16
About the Advanced X10 Programming Options
LampLinc can be a member of up to 255 X10 scenes. An X10 scene address is just another X10 address
like the X10 Primary Address. When an X10 ON command is sent to an X10 scene address, every X10
device with that address will turn on to its independent On-Level at its independent Ramp Rate (if a
dimmable device). Sending an X10 OFF command to an X10 scene address will turn off all devices that
are members of that X10 scene, each at its independent Ramp Rate. X10 devices will react to DIM and
BRIGHT commands after the X10 scene address is sent (if the device is a dimmer). However, they will
ignore ALL ON and ALL OFF commands for the X10 scene address.
Page 10 of 14