Page 4 of 10
2993-xx2 - Rev: 3/11/2014 9:21 AM 9:21:55 AM
Test Button Descriptions
Note: Unit under test = last responder linked
*This feature only works with INSTEON devices shipped after March 2012 (i2CS).
**Only applies to devices shipped prior to March 2012.
Directions
Note:
-
This manual presumes user has a moderate to expert understanding of INSTEON and INSTEON products.
-
Diagnostic Keypad only contains a single link. When you are finished testing a device, be sure to UNLINK it from
Diagnostic Keypad before linking your next device. If you link a second device without unlinking the first, it will
overwrite the existing link and the first device will still contain a half-link to Diagnostic Keypad. The first device
will have to be factory reset to remove the half-link.
-
UNLINK device upon completion of test. Otherwise, the device under test will retain a responder link.
ON/OFF
TOGGLE
Sends on/off broadcast
without confirmations to
unit under test
BEEP
Sends a beep message
to unit under test (some
responders will still
beep even after
unlinking from
Diagnostic Keypad)**
REPORT*
Monitors the quality of
control signals from the
device under test and
beeps upon receipt of
success reports
TRAFFIC
Blink on valid traffic
and long-beep upon
collisions/noise
DISTANCE
Sends alternating fast-
ons and fast-offs to unit
under test, beeping
upon receipt
LOCK/
UNLOCK*
Disable local setup of
unit under test
RELINK*
Relinks to last unit
under test
UNLINK*
Unlinks the unit under
test
