Page 7 of 16
2453-222/2453-422/2453-522 - Rev: 1/21/2014 7:51 AM
LED will start blinking green
4) Tap set button once
LED will start double-blinking green
5) Press and hold set button until it beeps
LED will turn green (at brightness of connected load)
6) Press and hold DIN Rail on/off buttons to brighten or dim LED to desired brightness
7) Tap set button until it double-beeps
DIN Rail will double beep and return to ready mode
Error Blink
By default, DIN Rail LED blinks red for a few seconds to acknowledge a communication error with a responder. This
setting is adjustable via software or central controller only.
INSTEON Setup
Some products have subtle differences in their setup procedures. Please refer to the other device’s owner’s manual
for details.
INSTEON Controllers, Responders and Links
Let’s define a few terms.
•
The INSTEON “transmitter” is called a
controller
•
The INSTEON “receiver” is called a
responder
Note: Some devices are controllers only (e.g., motion sensors, handheld remotes), some are responders only (e.g.,
FanLinc), and some can be controllers and responders (e.g., switches and dimmers).
•
The association between the controller and responder is called a
link
Note that a link is one way. If you want control the other way (making the responder a controller), and the devices are
capable of it, simply add a link “the other way.”
Make DIN Rail a Responder
Control DIN Rail from another INSTEON device:
1) Press and hold controller button until it beeps
Controller LED will start blinking
2) Tap DIN Rail paddle top or bottom to adjust load to on or off when scene
is activated
Connected load will respond appropriately
3) Press and hold DIN Rail set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test by tapping controller button on and off
Connected load will return to the state set in step #2
Note:
-
The link just created is one way. See “Make DIN Rail a Controller” to add another link to keep the two products
in synch, or see “Groups” section.
Make DIN Rail a Controller
Use DIN Rail to control other INSTEON devices:
1)
Press and hold DIN Rail set button until it beeps
DIN Rail LED will start blinking green
Controller
Responder
Link
DIN Rail
(Responder)
Controller
