Compliance Module
MiniMate Plus Operator Manual
3–3
4. Protect the MiniMate Plus from Water
The MiniMate Plus is splash resistant designed to withstand temporary exposure to drops of
water. It is not waterproof and should not be immersed in water. Immersing the monitor or
installing the monitor where standing water may accumulate may damage the monitor.
3.3.1. Soft Surface Installation
Always install and use the ground spikes provided with the MiniMate Plus and the standard
transducer. For the best coupling, bury the MiniMate Plus or the standard transducer.
a. Using the Ground Spikes
Screw the three ground spikes into the bottom of the MiniMate Plus or the standard transducer
and tighten. Aim the MiniMate Plus or the standard transducer in the direction of the event. Press
on the top of the MiniMate Plus or the standard transducer to push the spikes fully into the
ground. Check the MiniMate Plus or the standard transducer to ensure it is securely in place and
level. Press the
Test
key to check your sensors using Sensorcheck. Secure the lid to prevent it
from moving during an event.
WARNING
: Do not over-tighten the ground spikes. This can damage the casing of the MiniMate
Plus.
Figure 3.2 Installing the MiniMate Plus
Figure 3.3 Final Installation with Ground
using the Ground Spikes.
Spikes Pushed Fully into the Ground.
Summary of Contents for 716A0401
