TECHNICAL SPECIFICATION
Model
WB-2
WB-2/6KW
Width
mm
345
345
Depth
mm
600
600
Height
mm
585
585
Power Rating
KW
3.0
6.0
Weight (Empty)
KG
23
23.8
Weight (Full)
KG
28.3
29.2
Water Inlet Pressure:
Bar
2 to 7
2 to 7
INSTALLATION
IMPORTANT
To ensure that the unit works to its full potential, you will require water pressure of at least 30psi (2
Bar). If this is not possible, a pump should be fitted.
Having ensured that the incoming water pressure is adequate, follow these simple instructions:
1.
Provide a suitable stop-cock to isolate the machine for maintenance when needed
2.
Connect the water between the stop-cock and the boiler using the food quality hose
provided. (do not use red or blue washing machine hoses as these will contaminate the
water)
ELECTRICAL SUPPLY
3.
The 3kW model is fitted with a 13amp plug and should be plugged into a suitable socket. The
6kW model should be wired into a 30amp switched supply with an ELCB. (Only a suitable
electrician should undertake this work)
COMMISSIONING
4.
Open the steam tap on the left hand side of the unit
5.
Switch on using the switch on the front panel. The power light will illuminate and water will
start to enter the boiler. Once the bottom level sensor is reached. the unit will then start to
heat. When the water boils, steam will start to come from the steam nozzle. The steam tap
can then be closed.
6.
The pressure in the boiler will start to rise and the needle in the gauge will respond. When
the needle reaches the pre-set pressure, the ready light will illuminate and the boiler will
start to fill and heat until it reached the high level sensor. The boiler is then ready to use.
