Insta 718, Operation And Maintenance Manual

Page: 5 / 22

FOR USE BY QUALIFIED PERSONNEL ONLY
O ti Operation
1. Push POWER/MODE button on the controller
to turn ON machine. Hold POWER/MODE for
3 seconds to turn off machine.
2. Set desired temperature and select the
9. Swing away the upper platen to the opposite
side and remove substrate.
10. The DISENGAGE button may be pushed at
anytime to deactivate the machine.
desired timing cycle (see controller operation).
Swing the upper platen arm to its fully open
position, away from lower platen.
3. Allow the machine to warm up until the
selected temperature is reached.
NOTE
The air filter may be loose a little to
hinder the bowl from breaking
during handling. Do not touch the
polycarbonate bowl with synthetic
grease during operation and
maintenance Make sure your hands
4. Set the desired pressure by adjusting the air
pressure regulator.
5. Place the substrate on lower platen,
smoothing out all wrinkles.
6. Position transfer or lettering on substrate.
Environmental Conditions
Only operate Insta heat seal machines under
suitable environmental conditions
maintenance. Make sure your hands
are clean before touching the air
filter bowl.
g
7. Swing the upper arm into position directly
over the lower platen.
suitable environmental conditions.
1. Placed on a even, non flammable surface.
2. Can support a minimum of 300 lbs. if placed
above a platform.
3 D t t i t t th i
SAFETY DELAY FEATURE
For operator safety the machine
shall not operate unless the upper
8 Depress and hold both start buttons
3. Do not restrict access to the main power
switch.
4. Maintain a clearance around any forms of
liquid.
5. Do not over extend the power cord.
shall not operate unless the upper
platen has fully reached the left
hand position
. An additional safety
delay has been incorporated in
machines running software 2.29
(see point 8).
8. Depress and hold both start buttons
simultaneously until the lower platen contacts
the upper platen.
The start buttons must be
held until the upper and lower platens
make contact.
At this point the machine
operation is fully automatic. The platens seal
the transfer to the substrate and then release
automatically at the end of the selected timing
6. The operational voltage should not be 10%
max/min of the rated value.
7. Avoid voltage spikes.
8. Sound pressure level at operator station does
automatically at the end of the selected timing
cycle.
not exceed 70dB (A).
4