３
Safety Instructions
1)
The power cables, extension cables or power plugs are damaged.
2)
The products get wet.
3)
The products have fallen off or been damaged.
4)
Objects fall into the products.
5)
When operating according to the operating instructions, the products cannot
function normally.
2.
If the system is affected with damp, please dispose according to the following steps:
1)
Power off the equipment, disconnect them with the power socket, wait for 10 to 20
seconds, and then open the host cover.
2)
Move the equipment to a well-ventilated place to dry the system at least for 24
hours and make sure that the system is fully dried.
3)
Close the host cover, reconnect the system to the power socket, and then power on.
4)
In case of operation failure or abnormal situation, please contact Inspur and get
technical support.
3.
Pay attention to the position of system cables and power cables, wire them in places
not to be stepped on or knocked down and ensure not to place other objectives on the
cables.
4.
Before removing the host cover or touching the internal components, you shall cool
down the equipment first; to avoid damaging the mainboard, please power off the
system and wait 5 seconds, and then remove the components from the mainboard or
disconnect a peripheral device from the system.
5.
If there are modem, telecom or LAN options installed in the equipment, please pay
attention to the following matters:
1)
In case of thunder and lightning weather, please do not connect or use the modem.
Otherwise, it may suffer from lightning stroke.
2)
Never connect or use the modem in damp environment.
3)
Never insert the modem or telephone cables into the socket of network interface
controller (NIC).
4)
Before unpacking the product package, touching or installing internal components
or touching uninsulated cables or jacks of the modem, please disconnect the modem
cables.
6.
In order to prevent the electrostatic discharge from damaging the electronic components
in the equipment, please pay attention to the following matters:
