56
“
A
SSEMBLY
I
NSTRUCTIONS
”
S
TEP
2
–
Handrail Assembly
NOTE:
Two pcs
Nylock Nuts (M10xp1.5)(115)
will be pre-attached on each side of the Upper
Upright Post Assembly ; Total four pcs Nylock Nuts (115) will be pre-attached.
a. Remove two pcs
Nylock Nuts (M10xp1.5)(115)
from the right side of the
Upright Post
Assembly.
b. Attach the
Handrail Assembly (9)
to the
Main Frame Assembly (
1
)
by tightly securing with
3pcs
Nylock Nuts (M10xp1.5)(115)
and
1pcs Bolt (M10x65mm)(105).
c. Slide the
Upright Sleeve (38)
down until it meets the
Upper Motor Cover (22).
d. Follow the
FIG. A
, start fully tightening
2pcs Lock Washers (M10)(75)
,
2pcs Bolts
(M10x20mm)(102)
and
2pcs Nylon Nuts (M10xp1.5)(115)
that connecting to
Upright Post
Assembly
and
Main Frame.
e. Repeat the above same procedures on the left side.
S
TEP
3
–
Motor Cover & Wires Assembly
f.
Attach the
Right Side Motor Cover (36)
to the
Main Frame Assembly (
1
)
by securing
5pcs Bolt (M5x15mm)(88)
.
g. Repeat above same procedures on the left side.
h. Connect the
Middle Connection Wire (118)
to the
Rear Connection Wire (119)
.
Be care not to pinch the wires.
FIG. A
Summary of Contents for TA-7710
