![background image](http://html1.mh-extra.com/html/insportline/in-16920/in-16920_user-manual_2068929014.webp)
14
PEDALS INSTALLATION
All pedals have L or R stamped on the threaded spindle of each pedal.
1. Thread the pedal marked R clockwise into the right or chain
wheel side of the crank arm.
2. Thread the pedal marked L counter-clockwise into the left side
of the crank arm.
NOTE: Hand thread pedals into position without use of a wrench to
ensure threads are not crossed. Damage to crank arm will result from
crossed threads. When tightening with a wrench, make sure each
spindle is firmly seated against the crank arm. If jaws or wrench are
too thick, they may prevent proper tightening of pedal spindle against
crank arm.
SADDLE INSTALLATION
1. Insert the seat post into bicycle frame tube with small swaged
end up.
NOTE: Seat post must be inserted at least to the minimum
insertion mark stamped on the lower part of the post. If no
minimum insertion mark can be found, make sure at least 3 of
the post is inside the bicycle frame tube.
2. Tighten the seat post clamp nut securely. Recommended
torque is 120in/lb.
3. Loosen saddle clamp nut(s) so saddle clamp will fit down fully
onto top swaged end of seat post.
4. Tighten seat post bolt. Recommended torque is 150in/lbs.
SADDLE HEIGHT
1. Turn crank to place it in its lowest position.
2. Place heel of foot on pedal with foot parallel to the ground.
3. Position saddle so that toe of other foot can touch the ground.
Saddle should also be parallel to the ground and aligned
straight with the bicycle frame.
4. Tighten seat post bolt. Recommended torque is 150in/lbs.
NOTE: Seat post must be inserted at least to the minimum
insertion mark stamped on the seat post.