20
74
Magnetic core
1
75
Screw
M5*12
4
76
Bolt
M8*35
2
77
Screw
ST4.2*12
9
78
Safety band
Optional
1
79
Left handle bar
1
80
Right handle bar
1
81
Left support tube
1
82
Right support tube
1
83
Safety band hook
Optional
2
84
Hook
2
85
Triangle bolt
M6*10
6
86
Handpulse with speed
1
87
Handpulse with start/stop
1
TROUBLE SHOOTING
1. There is no display on screen after the machine is connected to the power source:
a. Please check the overload button, if the overload protector button bounces, please press it
down again;
b. Please make sure the power source, overload protector, the driver and the transformer are
connected well;
c. Please make sure the wires from the driver to the computer board are connected well.
2. E01 display: Unable to relay signal from the computer board to the driver
a. Please check the wire from the drive to the computer board, if the wire is broken, please
change a new one.
b. Please check the electronic parts in computer board, if it is wrong, change a new one.
c. Change a new transformer.
3. E02 display: Anti-explosion protection or a problem with the motor
a. Please check the wire from the motor and connect it well. If this is not a problem with wire
connection, please replace the motor.
b. If there is a bad smell from the control board, or if the IGBT has short-circuited, please change
a new driver.
c. Please make sure the voltage is in normal condition.
4. E03 display: No signal
a. If the E03 is displayed 5 to 8 seconds after the start, there is no signal. Please check the
connection of the sensor. If it is not connected well, try to connect it again. If the sensor does
not work well, replace it.
b. The control board signal is wrong, please replace the driver.
