10
STEP 4
Do not tighten until prompted. The assembly contains one cable, but the steps are divided for better
comprehensibility. Fasten the pulleys together with the cable.
Fig. 1 - Attach the 90 mm pulley (33) to the holder (15) with
the 3/8 ”X 1-3 / 4” bolt (42) and the 3/8
”nylon nut (57) together with the cable guided upwards.
Fig. A1, A2 - Attach 2x 90 mm pulleys (33) to the top frame (2) with 2x 3/8 "X 1-3 / 4" hex bolts (42)
and 2x 3/8 "nylon nuts (57) together with cable (35) guided according to the picture.
Fig. A3, A4, A5, A6 - Attach the 90 mm pulley (33) to the base (1) with
a 3/8 ”X 1-3 / 4” hex bolt (42)
and a 3/8 ”nylon nut (57) with a cable (35) guided according to the picture. Attach the 50 mm pulley
(34) to the main upright frame (3) with
a 3/8 ”X1-3 / 4” hex bolt (42) and a 3/8 ”nylon nut (57) with the
cable guided as shown (35). Repeat for B1 - B6.
Tighten all screws.
Important: The tension and length of the cable (35) can be adjusted by turning nuts A6 and B6. For
tensioning / shortening clockwise, for releasing / extending counterclockwise.