Insportline 10894, User Manual

Page: 11 / 24

11
Next, orient an Upright Spacer (26) as shown. Slide the Inner Cover (22) and the Right Upper Body
Arm (6) onto the right axle on the Upright (2).
Attach the Right Upper Body Arm (6) with an M8 x 20mm Socket Screw (57), an M8 Split Washer (63),
an M8 Large Washer (72), and a Plastic Washer (27) as shown.
Attach the Left Upper Body Arm (5) in the same way.
Attach Outer Covers (24) to the Inner Covers (22) on the Right Upper Body Arm (6) and Left Upper
Body Arm (5) with four ST4.2 x 12mm Self-Tapping Screws (66).
STEP 7
Identify the Right Pedal Arm (12), which is marked with a
sticker. Orient the Right Pedal Arm and one of the Pedals
(13) as shown.
Attach the Pedal (13) to the Right Pedal Arm (12) with two
M8 x 16mm Bolts (52), and M8 x 55mm Bolt (61), three M8
Washers (55), and three M8 Locknuts (58).
Attach the other Pedal (13) to the Left Pedal Arm (11) in the
same way.
Identify the Right Crank Axle (16), which is marked with an
“R.”
Apply grease to the Right Crank Axle (16) into the right
Pedal Arm Bracket (44). Next, slide the Wave Washer (74)
and a Crank Spacer (75) onto the Right Crank Axle.
Firmly tighten the Right Crank Axle (16) clockwise into the
right arm of the Crank (18). Then, firmly tighten the two
Right Thin Locknuts (36) clockwise onto the Right Crank
Axle.
Repeat this step on the left side of the elliptical.
Note: Turn the Left Crank Axle (not shown) and the Left
Thin Locknuts (not shown) counter clockwise to tighten
them!