Insportline 10894, User Manual

Page: 12 / 24

12
STEP 8
Apply grease to an M10 x 70mm Bolt (60). Attach the Right Pedal Arm (12) to the right Upper Body
Leg (64) with the M10 x 70mm Bolt (60), two M10 Special Washers (80), two M10 Split Washers (78),
two M10 Washers (62), two Nylon Washers (73), and an M10 Locknut (53) as shown. Make sure that
the Nylon Washers are between the Upper Body Leg and the bracket on the Right Pedal Arm.
See the inset drawing, Press a Dome Cap (14) firmly onto each M10 Special Washer (80); the Dome
Caps will snap onto the Special Washers.
Attach the Left Pedal Arm (not shown) to the left Upper Body Leg (64) in the same way.
STEP 9
The Console (23) can use four AA batteries (not included);
alkaline batteries are recommended.
Do not use old and new batteries together or alkaline,
standard, and rechargeable battery Compartment batteries
together.
IMPORTANT: If the Console has been exposed to cold
temperatures, allow it to warm to room temperature before
inserting batteries.
Otherwise, you may damage the console or other electronic
components.
Remove the battery cover from the back of the Console (23),
and insert batteries into the battery compartment. Make sure
to orient the batteries as shown by the diagram inside the
battery compartment. Then reattach the battery cover.
While holds the Console (23) near the Upright (2), connect the
console to the 3.5mm Wire (31). Insert the excess wire into the
Console (23) or into the Upright (2).
Tip: Be careful to avoid pinching the wires.
Attach the Console (23) to the Upright (2) with four ST4.2 x
12mm Self-Tapping Screws (66).
See Step 4. Tighten the three M8 x 20mm Button Screws (54)
and the two M8 Locknuts (58).