kanga lateral trunk supports,
qr-removable
Item Number
3040-021010
Kanga Lateral Trunk Supports, Removable, 10” (pair)
3040-021012
Kanga Lateral Trunk Supports, Removable, 12” (pair)
3040-021014
Kanga Lateral Trunk Supports, Removable, 14” (pair)
Tools Needed:
5/32 allen wrench
Contents in package (qty):
(2) Track mount bracket
(1) QR lateral mounting packet
(2) QR mounting base
(2) lateral bracket, flush mount with pads (attached)
(2) lateral bracket, 1inch Offset (optional use)
NOTE -
It is best to dry-fit hardware in-place prior to
cutting holes in upholstery. This installation is easiest with
the contoured back removed from the wheelchair, lying
rear side up flat on a solid surface.
1.1
On the rear side of contoured back ( I cut-out area)
choose either left or right side, locate the (2) t-nut holes
through upholstery, carefully cut upholstery to access
t-nuts.
1.2
Open the lateral mounting packet and remove (2)
screws, use screws to attach track mount bracket with
lateral assembly to the contoured back.
1.3
Repeat above steps for opposite side.
1.4
Locate the silver pull knob attached to the QR mount-
ing base, lift and rotate the knob to “unlocked” position.
1.5
Adjust the lateral bracket on the QR mounting base
to the desired width location, rotate and release the pull
knob to allow it to “lock” into desired hole on the lateral
bracket to hold desired lateral width position.
1.6
Lateral height adjustment; loosen the QR mounting
base and slide up or down track mount to desired height
position. Fully tighten all bolts to secure pads, brackets to
the track.
assembly
