step two - Installing hardware to
wheelchair frame
step three - attaching seat/back
to wheelchair frame
2.1
Open the package labeled “seat knob clamp hard-
ware” loosen the large plastic hand knobs and attach the
seat knob clamps onto the seat mount brackets.
2.2
Locate the desired position for the seat/back within
the wheelchair frame. Using a pencil or a non-permanent
marking tool, mark the desired position for the seat/
back knob clamps on the wheelchair seat rails and back
canes. Remove the seat knob clamps from the seat mount
brackets.
2.3
Attach the seat knob clamps on the marked position
on the wheelchair seat rails.
2.4
Remove the right/left back knob clamps by loosening
the large plastic hand knobs.
2.5
Attach the right/left back knob clamp on the marked
positions on the wheelchair back canes.
2.6
Use tape measure and verify that both seat knob
clamps measure the same distance from a specific refer-
ence point on the wheelchair seat rails.
2.7
Repeat step 2.6 for the back knob clamps mounted to
the wheelchair back canes.
Attach the seat by aligning the seat mount brackets onto
the seat knob clamps attached to the wheelchair seat
rails.
Align the back knob brackets onto the back knob clamps
on the back canes.
Tighten all four of the large plastic hand knobs to secure
the seat/back in place.
Final adjustments for installing/removing seat/back, make
all necessary fine-tuning adjustments so that seat/back
assembly installs/removes properly. Do a final check and
tighten all hardware and plastic hand knobs prior to posi-
tioning client into wheelchair.
