Deck Plate
Mounting Gasket
Property Damage:
Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
2
Q
Unpack faucet components.
Q
On a firm, flat surface, carefully
straighten the copper tubing.
A
C
D
INSTALLING THE FAUCET
5
Q
Slide plastic mounting gasket over
all tubes descending from faucet
body and seat mounting gasket into
bottom of faucet until flush.
Q
Position supplied deck plate over
the hole into which the faucet will
be installed.
Q
With mounting gasket in place, feed
tubes down into hole until faucet
rests on deck plate (see illustration).
B
Q
From under the sink, place the
metal mounting plate onto the
threaded stud.
Q
Make sure faucet head is at the
desired angle.
Q
Place the supplied lock washer and
hex nut on to the threaded stud.
Q
Tighten to secure the faucet to the
sink top.
Do not overtighen.
The wall outlet for your faucet must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates a food waste disposer.
PREPARATION
START HERE
PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS
Q
Identify locations for the faucet and
tank.
Q
Check to make sure there is proper
clearance for faucet handle to be fully
opened.
Q
Check to make sure counter is not
too thick.
Q
Make sure there is a grounded
electrical outlet under the sink.
Q
Turn off water supply.
Q
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
Q
Using adjustable wrench, remove nut
connecting sprayer washer flange in
sprayer hole.
Q
Plug hose opening with either a 1/8"
plug or a 1/4" cap
(not supplied).
1
A
B
4
Consult a professional before drilling into
a surface other than stainless steel.
C
What if you don’t have a sprayer hole or
don’t want to use it?
Q
If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the faucet with a
hole saw for stainless steel, or you can
use a hole punch.
Required Hole Diameter
1
1
⁄
4
" - 1
1
⁄
2
"
Required minimum from
center of hole to wall
Maximum counter
thickness (depth)
2
"
1
1
⁄
2
"
B