FEATURES
INTRODUCTION
The CC-101 K Control Center is UL listed for use with ISE
Commercial Food Waste Disposers. See Table 1 for approved
disposer and control center combinations. The control center
operates the commercial disposer. Its main functions are:
• To start and stop the disposer
• To reverse the direction of the disposer motor automatically
upon restart.
• To start the water flow to the disposer.
• To allow water flow for several minutes to flush the drain line
after the disposer is turned off.
TABLE 1. Approved Disposer and Control Canter Combinations
Model
Waste Disposer Model
CC-101K1
CC-101K2
SS50-26, SS75-27, SS100-28, SS125-25
SS150-34. SS150-38, SS200-27, SS200-31
CC101K3
CC101K4
SS550-27, SS75-28. SS100-29, SS125-26,
SS150-36, SS150-39, SS200-29, SS200-32,
SS300-25, SS300-27, SS500-28, SS500-30
SS750-13, SS750-15. SS1000-10, SS1000-12
The control center models and specifications are shown In Table 2
TABLE 2. Electrical Specifications
Model
Voltage
Phase
hp
CC-101K-1
120V
10
1/2-2
CC-101K-2
208-240V
10
1/2-2
CC-101K-3
208-204V
30
1/2 -10
CC-101K-4
380-460V
30
1/2-10
FEATURES
AUTOMATIC REVERSE
The disposer motor will reverse its direction of rotation automatically
upon restart. To avoid motor damage, a five second delay feature
prevents reversing while the motor is coasting.
WATER SHUTOFF DELAY (POST FLUSH)
After the motor is turned off. the water continues to flow for up to 10
minutes. The length of this post flush is controlled by the water
shutoff delay timer. The post flush helps ensure that ground food
waste is flushed out of the drain line. Adjust water shutoff delay as
described in the operating instructions on page 9.
AUTOMATIC TIMED DISPOSER SHUTOFF
This water saving feature allows the disposer to run for up to 10
minutes before it automatically shuts off and must be manually
restarted.
NOTE: This feature is set in the OFF position at the factory. To
activate the automatic timed disposer shutoff, disconnect the
electric power to the control center, then open the control center
door. Locate the shutoff plug at the top of the circuit board (See
page 9, Figure 16). Move the plug from manual (MAN) pins to
automatic (AUTO) pins. The disposer now automatically shuts off
10 minutes after it starts.
EXTERNAL REMOTE CONTROL
One or more remote controls may be connected to the control
center. These enable the operator to start or stop the disposer from
any control station. A 24 V control circuit provides low voltage push
button operation.
ELECTRIC DISCONNECT SWITCH
The lever switch on the front panel of the control center disconnects
line voltage. It interlocks with the front cover so that the cover
cannot be opened unless the switch is in OFF position.
LOW VOLTAGE CONTROL
Controls operate on a 24 V solid state control circuit.
ENCLOSURE
Stainless steel NEMA 4 construction.
PUSH BUTTON OPERATION
Push black button to start disposer.
Push red button to stop disposer.
2
