TROUBLESHOOTING
WARNING
TROUBLESHOOTING
•
Do not put fingers or hands into the disposer.
•
When attempting to remove objects from a disposer, use long-
handled tongs or pliers.
ELECTRICAL SHOCK/PROPERTY DAMAGE
•
Turn power off before clearing a jam, removing an object from
the disposer, or pressing the red reset button.
•
Disconnect electricity before adjusting.
• Troubleshooting other than what is recommmended in this
section should only be performed by qualified service per-
sonnel.
C. Disposer will not start but water flows.
• Further troubleshooting performed by untrained personnel
could result in electric shock or damage to the control center.
• All electrical checks must be performed by a qualified pro-
fessional.
1. Overload protector on the disposer may have tripped. Press
stop botton. Locate red reset button on front of disposer
electrical cover. Press to reset. If motor had been running, wait
five minutes for the motor and overload to cool down.
2. Disposer jammed. Press stop button and follow directions for
unjamming supplied with disposer.
This control center was inspected and tested under operating
conditions before shipment from the factory. In case of trouble
check the items listed below.
A. Disposer motor will not start and water does not flow.
3. Disposer motor or control center wires may be improperly
connected. Recheck wiring diagram on page 12,13, 14 or 15.
1. No incoming line power. Turn line power on.
.
Water flows constantly before start button is pushed.
2. Electric disconnect switch is not on. Turn electric
disconnect to ON position.
3. Control circuit fuse FNA2 is blown. Replace fuse.
1. Water solenoid valve is installed backward. Water flow should
be in direction of arrow on valve.
CAUTION
2. Water solenoid valve is wired incorrectly. Recheck wiring
diagram on page 12,13,14, or 15.
PROPERTY DAMAGE
If trouble still persists, call your nearest ISE Authorized Service
Agency. For the location of your nearest service agency, call toll
free 1-8000-558-5700.
Use only an FNA2 replacement fuse. Using another replacement
fuse will result in product damage.
B. Disposer motor stops while grinding but water continues to
flow.
1. Control center wired for automatic shut-off. Repress start
button. If disposer runs for 10 minutes then shuts off, the
automatic shutoff is active. If the manual setting is desired,
change as indicated in the feature section.
2. Disposer is jammed. Press stop button and follow directions for
unjamming supplied with the disposer.
3. Disposer motor overload protector has tripped. Follow
instructions in C1.
11
