Insinger Eliminator 900, Technical Manual

Page: 18 / 44

Pulper DOC PULPER 1.0 06
www.insingermachine.com 800-344-4802
16
PART 4 MAINTENANCE
Extractor Seal Replacement
Remove the extractor outlet assembly, the auger
assembly and the extractor screen from the extrac-
tor. Remove all debris and fouling material from
the drive shaft and bore.
Pick out old seal being careful not to damage or
scratch the shaft or the seal holder bore. Clean
any debris remaining on the shaft and in the bore.
Apply a thin film of o-ring lubricant on the sealing
surface of the seal. Place the seal onto the drive
shaft being careful not to damage the seal.
Excessive force should not be required. Gently
press the seal down onto the shaft and into the
bore.
Using a 2” PVC or other plastic pipe with a straight
cut, smooth & debureed face with no sharp edges,
gently tap the seal into the bore.
Reassemble the extractor in reverse order.