NVS410 User’s Guide
-
-
-
- 20
20
20
20 -
-
-
-
"
System Name
It is the name of the NVS410. It is the same as the one set-up by the IP-installer. You can reassign the
system name in admin mode.
"
Audio Input Selection
-
Select the type of input audio. Line-In is used for connection of external audio devices and Mic
is used if the external device is a microphone.
-
Input Gain: Selectable gain for the input line.
"
Video Quality & Bandwidth Control
- Input Video Source : Select the analog video standard for input. Select one from NTSC, PAL, SECAM.
- Video Size : Select a video size for transmission. Allowed video sizes are different for each video standard.
- NTSC(30 frames/sec Max.) : 320x240 / 640x480.
- PAL (25 frames/sec Max.) : 352x288 / 704x576.
- SECAM (25 frames/sec Max.) : 352x288 / 704x576.
#
Max upload rate
o
Assign maximum bandwidth of the uplink for the network connected to NVS410.
#
Frame
rate
o
Assign number of video frames transmitted for each second. You can improve picture quality by
lowering frame rate for the same bandwidth.
#
Video
rate
o
Assign bandwidth for transmitting video data.
#
Audio
rate
o
Assign bandwidth for transmitting audio data. Audio data is not transmitted if you select “
NA
”
"
Check
After you finish setup of video and audio for all the channels, click on this button to obtain the possible
maximum number of users (Possible Max Users) and network bandwidth margin (Remained) remaining.
The Check tool will calculate the number of users able to view the video stream without any quality
degradation or network congestion.
"
Possible Max Users
It shows the number of maximum simultaneous connections for the network connection set-up.