INOXPA is not liable for any deterioration of the material caused by its transport or
unpacking.
When receipt the control head, check to see whether all the parts listed on the delivery slip are
present:
- control head,
- instruction manual.
INOXPA inspects all control heads before packaging. However, it cannot guarantee that the
merchandise arrives at the user intact.
When unpacking the valve:
- take all possible precautions against damage to the control head and its components,
- inspect the valve or the parts that comprise it for possible damage incurred during shipping.
5.1. RECEPTION OF THE CONTROL HEAD
5. Installation
5.2. TRANSPORT AND STORAGE
The buyer or user shall be liable for assembly, installation, start-up and operation of the
control head.
Take all possible precautions when transporting and storing the control head to avoid damaging it
and its components.
5.3. IDENTIFICATION OF THE CONTROL HEAD
Each control head is inscribed a fabrication number for its identification. indicate the fabrication
number on all documents to refer to the control head.
5.4. LOCATION
Place the control head leaving enough space around it to realize easily the dismantling, the inspec-
tion and the review of the control head. The installation should allow that the removable parts are
could remove easily.
5.5. MECHANICAL INSTALLATION OF THE CONTROL HEAD
All the installation work of the control head should be carried out by specialised personnel.
Always follow the instructions of the present manual.
Check that the compressed air and power supply are switched off and the actuator is
pressureless before starting the assembly or disassembly works.
Instalación
9
INOXPA S.A.U.
10.426.30.03EN · (0) 2022/01
