INOXPA C-TOP S, Installation, Service And Maintenance Instructions

Page: 16 / 23

6.3.2. Maintenance mode
The maintenance mode is used to activate the solenoid valves manually.
To entry to the maintenance mode, situate the DIP switch 4 in the ON position.
The entry to the maintenance mode is indicated with a white flashing light for 2 seconds.
Once inside the maintenance mode, the solenoid valves can be activated manually doing pressing
the “ I ” and “ II ” buttons according to the combinations of the following table:
“ I ” button “II ” button
Activate
solenoid valve
Pressed Not pressed 1
Not pressed Pressed 2
Pressed Pressed 3
Not pressed Not presseg None
If the control head is configured for each solenoid valve that is activated manually, the control head
will be illuminated by the corresponding configured colour. If instead, the control head has not any
configuration, the control head will be illuminated by a white light.
To finalize the maintenance mode, situate the DIP switch 4 in the OFF position. The end of the
maintenance mode will be indicated by a flashing light for 2 seconds.
To restore the default settings, reset the control head pressing the “
I
” and “
II
” buttons until the
control head illuminates by a white continuous light.
6.4. RESET
The control head is illuminated by different colours to inform the status of the valve and the control
head. There are some default colours and other ones that be chosen to configure the different
positions of the valve.
The default colours to operate the C-TOP S are:
- White: to get in and out of the different operating modes. If no change has occurred at the exit
of the setting mode, the light of the control head will be flashing. Instead, if any changes have
occurred, the light of the control head will be continuous.
- Pink: to indicate transition.
- Red: to indicate an electronic fault.
DIP 1 DIP 2 DIP 3 OUT 1 OUT 2 OUT 3 OUT 4
0 0 0 blue green yellow orange
1 0 0 green blue yellow orange
0 1 0 green yellow blue orange
1 1 0 blue yellow green orange
0 0 1 yellow blue green orange
1 0 1 yellow green blue orange
0 1 1 blue green orange yellow
1 1 1 green blue orange yellow
Other colours can be configured for each outlet according to the following table:
6.5. COLOUR CODING
Puesta en marcha
INOXPA S.A.U.
10.426.30.03EN · (0) 2022/01
16