3.1. WARNING SYMBOLS
3. Security
Safety hazard for people in general and/or for the control head
Electrical hazard
ATTENTION
Important instruction to prevent damage to the equipment and/or its function
3.2. GENERAL SAFETY INSTRUCTIONS
Read the instruction manual carefully before installing and starting the control head.
Contact INOXPA in case of doubt.
For a reliable and without problems function follow the instructions of this manual.
This control head cannot be used in atmospheres where exist explosion hazards.
The installation and the use of the control head always must be following the health and
safety applicable regulations.
3.2.1. During installation
Always take into account the
Technical Specifications in chapter 8
.
Use the device only for its intended use and only with the recommended equipment by
INOXPA.
Before performing the installation ensure that the compressed air and the power supplies
are switched off and that the actuator of the process valve is pressureless.
Ensure that the power supply does not restart.
All the electrical work should be carried out by specialised personnel.
Only use power supplies that guarantee reliable electrical isolation of the operating
voltage as per IEC/DIN EN 60204-1.
Observe the general requirements for PELV circuits in accordance with IEC/DIN EN
60204-1.
Installation errors can damage the electronics or cause malfunctions.
The C-TOP S contains electrostatically sensitive components. Electrostatic discharge
caused by improper handling or incorrect earthing can damage the internal electronics.
3.2.2. During operation
Always take into account the
Technical Specifications in chapter 8
.
Only use the product if it is in perfect technical condition.
NEVER exceed the specified limit values.
Do not touch the inside of the control head when it is in operation.
Seguridad
INOXPA S.A.U.
10.426.30.03EN · (0) 2022/01
6
