ED. 2010/11
1.Safety
3
1.
Safety
1.1.
INSTRUCTION MANUAL.
This instruction manual contains basic indications which should be fulfilled during the installation, starting and maintenance.
The information published in the instruction manual is based on updated information.
INOXPA reserves the right to modify this instruction manual without prior notice.
1.2.
START-UP INSTRUCTIONS.
This instruction manual contains essential useful information to handle and maintain your valve appropriately .
Not only should the safety instructions indicated in this chapter be observed and fulfilled, but so should the special measures
and recommendations included in the other chapters of this manual. These instructions should be kept in a safe location near
the installation.
1.3.
SAFETY.
1.3.1.
Warning symbols.
General danger of injury
Danger of injuries caused by the rotary
parts of the equipment
Electrical hazard
Danger! Caustic or corrosive agents.
Danger! Suspended loads
Danger for the correct operation of the
equipment.
Compulsory requirement to ensure safety
at work
Use of goggles is compulsory.
1.4.
GENERAL SAFETY INSTRUCTIONS.
Read the instruction manual carefully before installing and starting up the valve. Contact INOXPA in
case of doubt
1.4.1.
During the installation.
of Chapter 8 should always be observed.
The installation and use of the valve should always be carried out in accordance with applicable
regulations regarding health and safety.
Before starting up the valve, verify that the assembly is correct and that the shaft is perfectly
aligned. An incorrect alignment and/or excessive force in securing the valve may cause serious
mechanical problems in the valve.
1.4.2.
During operation.
of Chapter 8 should always be observed. Under no circumstances can the
limit values specified be exceeded.
NEVER touch the valve and/or the tubes in contact with the liquid during operation. You risk being
burnt if you work with hot products.
