3
1.
PEOPLE SAFETY
RISKS OF ELECTROCUTION OR EXPLOSION
Read carefully this installation guide before using the inverter.
The user has to conform to all the requirements of the international and national regulations about the
earthing of all the equipments.
DO NOT touch the internal parts of the inverter : use only tools isolated electrically
DO NOT touch the terminal blocks when the inverter is supplied.
DO NOT put in short circuit borders DC+1 and DC+2 or condensers of the bus DC. A high tension which
can cause electric shocks remains present in the device after cutting the supply.
DO NOT try to fix the inverter; you should contact your retailer.
Put back in place and close all the lids before putting back the inverter under tension.
The inverter must be carefully fixed before switching it under tension.
Before any intervention on the motor, power supply of the inverter must be turned off.
NON-RESPECT OF THESE RULES MAY BE FATAL: DEATH, SERIOUS INJURIES AND MATERIAL DAMAGES
2.
MATERIAL SAFETY
Verify that the inverter VFR-013 is not damaged
Verify that the inverter corresponds to your order and to the delivery note.
Verify that the tension of the electric network corresponds to the supply power of the inverter : 220V
single phase or 400V three phase
Never turn off the supply power if the inverter before the end of the motor operations.
An armored cable must be used for the control circuit, and this one must be taken away as much as
possible from the circuit of power to avoid the disturbances.
When the frequency of hashing is lower than 3 KHz, the distance between the inverter and the motor
must be at the maximum 50 meters.
If the inverter has to start frequently, do not turn off it power supply, but use the starting up at the
terminal blocks, to avoid some damages.
Never connect a supply power on terminals U, V, W of the inverter; otherwise it would be immediately
destroyed.
The inverter capacity in KW and A should always be higher than the motor capacity.
WARNING; IF THE INVERTER IS DAMAGED; DO NOT USE IT
Summary of Contents for VFR-091
Page 6: ...6 From 11KW to 160KW ...