Inoksan INO-SDF070/S, Instruction Manual

Page: 17 / 28

7. CLEANING AND MAINTENANCE

Always plug-out the appliance before starting
any cleaning or maintenance work.

A clean cloth immersed into warm soapy water
is adequate to clean the device.

Do not use abrasive detergents or wire brushes
that may scratch the surface or any other similar
material and appliance of such nature during
cleaning.

You can employ chemical solvents to clean
tough stains on the surface that cannot be
removed by means of the above mentioned
methods.

Dust the condenser surface and its vicinity
periodically as dust depositing on the condenser
may hinder the efficient operation of the device.

The fan motor should be lubricated on a 15-day
basis at most (This period may be less according
to the operating environment of the device).
Failure to effect maintenance on the condenser
and fan motor reduces the operating efficiency
of the device and may further give rise to the
burn-out of the condenser.

Excessive frosting in refrigerator’s evaporator
(chilling chamber) is an adverse factor that
reduces the operating efficiency of the device
and leads to further problems. To ensure a long
life of the device, strictly effect defrosting
whenever any frost occurs.

Avoid cleaning the device with direct or high-
pressure water jet; otherwise your electrical
installation may be broken down.

In case you notice any risky condition in the
device,
immediately call the authorized
technical service (please specify especially the
serial number and model information inscribed
on the label attached to the edge of the device).
Do not allow unauthorized people to effect any
operation on the device; otherwise it will fall out
of the warranty coverage.

In addition, maintenance or repair of any
malfunction arising out of your failure to satisfy
the maintenance work under your liability will
be charged separately.
8. TROUBLESHOOTING
The appliance fails to refrigerate:

Check the thermostat’s current refrigerating
position and increase it if necessary.

Check that the condenser unit is clean. Remove
any dust and dirt from this unit.

The evaporator may excessively be frosted. Plug
out the appliance and allow defrosting.

In case the appliance is directly exposed to
sunlight, it may fail to fulfil the refrigeration
process perfectly. Change your appliance’s
location.

If ambient temperature exceeds +35
o
C, the
device cannot operate normally. Check the
ambient temperature.

If the appliance fails to refrigerate even after the
above mentioned remedies are satisfied, contact
with the authorized technical service.
The appliance fails to run automatically:

Check the thermostat switch. Turn it on and off.
If thermostat runs properly, the failure stems
from any other cause.

Check the cleanliness of the condenser unit. If
necessary, remove contaminants such as dust
and oil from the surface of the condenser.

Check the proper operation of the fan motor. If
rotation of the fan motor is not sufficient,
demount the fan motor and lubricate it.

If the problem prevails, contact with the
authorized technical service.
The condenser fails to run:

Check the availability of the power supply in the
socket.

Check whether the thermostat switch is on or off.

Check whether the condenser’s chilling fan runs
or not.

If all units and functions operate properly but
the condenser is still out of work, contact with
the authorized technical service.
The condenser gives out unusual noise:

Check the cleanliness of the condenser. Remove
and dust and dirt.

Effect the periodical maintenance of the fan
motor.

If the failure still prevails, contact with the
authorized technical service.
9. POSSIBLE ERRORS AND REMEDIES