TNi21
07 April 2016
Page
32/38
8.3.2. Equivalent outputs diagram
PNP outputs to 50mA max. open slip-ring
Fit a pull-
down resistor (recommended value 4.7 kΩ).
CAUTION
EARTHING THE OUTPUTS
The accidental earthing of the outputs or connecting them to a capacitive load will
result in them being destroyed.
Before powering up the motor, check that the outputs are wired correctly.
If these precautions are not taken, the result could be injury or damage to
equipment.
Figure 11
Caution
: the output level is equal to the motor's supply voltage:
if V DC = 32V then S1 / S2 / S3 = 32V.
If there is rejection, the voltage increases as a result; it may rise to the maximum of 56V (over-voltage
threshold value).
If, for your application, it is necessary to limit the voltage at these outputs, you should make the following
arrangement.
Figure 12
Client output (24V)
