NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
6
MANUAL CONTROL PANEL OPERATION
(refer to
Figures 5 & 6)
Once this appliance has been properly installed
and connected to the power supply as defined
in this manual, it is ready to operate.
Note: Ensure the circuit breakers for the power
supply are turned on.
This appliance can be operated either from the
manual control panel (see
Figures 4 & 5)
or
by using the remote control, wall switch or wall
thermostat (optional kits).
The manual controls are located on the fire-
box floor on the front left (see Figure 5). If an
optional glass enclosure is installed, it must be
removed to access.
Main Power ON/OFF Switch
When the main power switch is turned on, power
is supplied to the fireplace. This switch must be
on for all other switches to operate.
Heater ON/OFF Switch
When this switch is turned on, the heater will
emit heat in the temperature range selected (see
Figure 6; G, H & I)
. The fireplace can operate
with or without heat.
Flame / Ember On/Off Switch:
Turns lights on inside ember bed and flame
cylinder.
MANUAL CONTROL PANEL
Main Power On/Off
(rear most switch)
Figure 4
FINAL FINISHING
Materials such as brick and tile can be extended
down to the top of the fireplace. Do not extend
down, covering the outlet or glass enclosure
panel (optional kit).
There are a wide variety of “finished looks” for
these fireplaces, from formal wall decor with
elaborate mantels to rustic wood paneling or
warm brick facings.
Accent Trim Installations
An optional accent trim kit is available from your
dealer (see
Page 17).
These options give the
appliance an attractive finished look.
Hearth
An aesthetically pleasing fireplace hearth can
be installed, if desired (see hearth protection
on
Page 5).
bREAK-IN PERIOD:
During the first few initial uses of this heater,
there may be a release of a slight, harmless
odor. This odor is a normal occurrence caused
by the initial heating of the internal heating
elements and should not reoccur.
Flame / Ember On/Off
(front most switch)
Manual Control Switches
are located behind pull
screen on inside floor
Figure 5
On
On
On
Off
Off
Off
• When using the main
power on/off switch
inside the manual control panel, the
power
on/off switch
outside the manual control
panel (optional wall switch kit) must be in
the OFF position.
• When using
power on/off switch
outside
the manual
control panel (optional wall
switch
), the
power on/off switch
inside the
manual control panel must be in the OFF
position.
• When using the
remote control
, the
power
on/off switch
inside the manual control
panel and the
wall switch
(optional kit)
must be on the OFF position.
Heater On/Off
(center switch)
