Copyright Innovative Technology Ltd 2012
GA401-5
SMART HOPPER OPERATIONS MANUAL
21
21
APPENDIX C – eSSP COMMANDS
Table 10 - SMART Hopper eSSP Commands shows the eSSP commands for the SMART
Hopper. These commands are in addition to the Generic commands. See document
number GA138 for the full eSSP specification. Commands marked with an asterisk (*)
must be encrypted
Action
Command Code (HEX)
Get Device Setup
0x05
Payout Amount(*)
0x33, value
Set Coin Amount(*)
0x34, number, value
Get Coin Amount
0x35, value
Halt Payout(*)
0x38
Set Coin Routing(*)
0x3B, route, value
Get Coin Routing(*)
0x3C, value
Float(*)
Ox3D, min payout, float value
Get Minimum Payout
0x3E
Set Individual Coin Accept Inhibit(*)
0x40, state, value
Empty(*)
0x3F
Host Serial Number Request(*)
0x14, Serial N
o
Table 10 - SMART Hopper eSSP Commands
Get Device Setup: Single byte command used to request information about the hopper.
Payout Amount: Five-byte command to set the value to payout.
Set Coin Amount: Five-byte command used to inform the hopper of coins being added.
Get Coin Amount: Five-byte command that returns the coin count for a given value.
Set Coin Routing: Six-byte command to set the routing of each coin value. Coins can either
be routed to the cash box, or recycled and used for payouts.
Set Coin Routing: Five-byte command that returns the routing for a given value
Float: Seven-byte command that sets the minimum payout value and the value to float to
Get Minimum Payout: Single byte command that returns the minimum payout value.
Set Individual Coin Accept Inhibit: Four-byte command that is used to enable or disable
acceptance of individual coin values from a coin acceptor connected to the hopper.
Empty: This command will route all coins to the cash box without reporting any value and
reset all the stored coin counters to zero.
Host Serial Number Request: Allows the host machine to send its serial number to the
hopper. This may be used as an extra check that the host is authentic.
