b) For CY1 & CY2 :
1 - 9999
10.0
OFF TIME: Prompted only if selected timer mode is CY1 or CY2 . It sets
Off time for CY1 & CY2 modes.
OFF TIME
Range
Lower
Display
Description
Default
Parameter
Upper
Display
1 - 9999
10.0
ON TIME : Prompted only if selected timer mode is CY1 or CY2. It sets On
time for CY1 & CY2 modes.
ON TIME
0
NUMBER OF
CYCLES
1 - 9999
NUMBER OF CYCLES : Prompted only if selected timer mode is CY1, Cy2
or CY3. This parameter is enabled only when Repeat cycle is selected as
“NC”. It sets the number of cycles after which both the Relays will be
OFF.
0
TOTAL
TIME
1 - 9999
TOTAL TIME
:
Available for CY1, CY2 or CY3 mode. This parameter will be
prompted only if “TOT” is selected in repeat cycle. In This mode when
Total time is over (Programmed in Min. only); Both relays will be off.
NOTE:
1) In CY1 mode the OFF time will be executed first followed by the ON time.
2) In CY2 mode the ON time will be executed first followed by the OFF time.
UPPER
DISPLAY
LOWER
DISPLAY
Run Mode
a) For On & Off Delay Mode:
Hrs
Min
Sec
Hrs
Min
Sec
a) For Cyclic Mode:
Running Time
UPPER
DISPLAY
LOWER
DISPLAY
Hrs
Min
Sec
Hrs
Min
Sec
Hrs
Min
Sec
Set Time
Set EOC Time
Running Time
Set Time
Number of cycles
Total Time
b) For CY3:
0.01 - 999.9
5.0
FORWARD TIME
: Prompted only if selected mode is CY3 (Cyclic with
Hold). Sets the FORWARD time for motor.
FORWARD
TIME
Range
Lower
Display
Description
Default
Parameter
Upper
Display
0.01 - 999.9
5.0
REVERSE TIME
: Prompted only if selected mode is CY3 (Cyclic with
Hold). Sets the REVERSE time for motor.
REVERSE
TIME
0.01 - 999.9
5.0
HOLD TIME
: Prompted only if selected mode is CY3 (Cyclic with Hold).
Sets the HOLD time between motor Forward & Reverse.
HOLD
TIME
0
TOTAL
TIME
1 - 9999
TOTAL TIME
:
Available for CY1, CY2 or CY3 mode. This parameter will
be prompted only if “TOT” is selected in repeat cycle. In This mode when
Total time is over (Programmed in Min. only); Both relays will be off.
0
NUMBER OF
CYCLES
1 - 9999
NUMBER OF CYCLES
: Prompted only if selected timer mode is CY1,
Cy2 or CY3. This parameter is enabled only when Repeat cycle is
selected as “NC”. It sets the number of cycles after which both the
Relays will be OFF.
7
Document Name : OIM V 1.0 Page 7 of 7
413, New Sonal Link Service Industrial Premises Co-op Society Ltd,
Building No.2, Link Road, Malad (W), Mumbai - 400064.
Tel: 022-66939916/17/18;
E-mail : [email protected]
Website : www.itherm.co.in
Mfgd by: Innovative Instruments & Controls LLP
i
