496332 Issue 1
15 of 22
Leaving Engineering Mode
Before leaving Engineering Mode, check that the Bell, Strobe, all detectors,
tampers etc., are connected. Also check that the 6.Ah standby battery is
connected and all lids are closed on LIMs, keypads and main control panel.
If your system is fitted with remote signalling, check that it is programmed for
‘Engineer Reset’, and proceed as follows:
The display shows:
Do you want to
engineer reset?
1.
Press Yes
The display shows:
Branch 1
No of LIMs=5
Followed by:
Branch 2
No of LIMs=7
Followed by:
Branch 3
No of Lims=8
9500
Leaving Engineering Mode
Summary of Contents for 9500
Page 4: ...4 of 22 496332 Issue 1 Wiring Figure 2 Main PCB Layout Figure 3 Main PCB Connections 9500 ...
Page 12: ...12 of 22 496332 Issue 1 Engineering Program Commands 9500 ...
Page 13: ...496332 Issue 1 13 of 22 9500 Engineering Program Commands ...
Page 14: ...14 of 22 496332 Issue 1 Engineering Program Commands 9500 ...
