11
gauge interface, you will also see a real-time display of the RPM to
ease the setup. Default is 1 pulse per rotation.
2.
Scale (RPM Scale) –
Select either 10230 or 20460 RPM scales.
Default is 10230
3.
Shift RPM –
Set to desired RPM to trigger illumination of the shift
light on the PSB-1. Default is 10230 RPM.
3.4
Relay Settings (Gauge Abbreviations)
In an O2 error state, all relay functions are automatically
disabled.
1. Boost Cut by Pressure
(
Boost Cut Press)
- This is a safety trigger to
cut boost at a desired maximum manifold pressure. When the safety
Boost Cut by Pressure is triggered, the PSB-1 will display “B Cut” on the
upper right hand corner viewport and the relay will interrupt all solenoid
control and boost will default to spring pressure. Default setting is 8 PSI.
2. Boost Cut by AFR
– This is a safety trigger to cut boost by a defined
AFR. There are two setup parameters to trigger this safely cut:
Start
Pressure (AFR Start Press)
and
AFR Cut. Start Pressure (AFR Start
Press)
is the minimum manifold absolute pressure where the safety cut
will become active.
AFR Cut
is the defined lean A/F that will trigger the
safety cut. When the
Boost Cut by AFR
is triggered, the PSB-1 will
display “O2 Cut” on the upper right hand corner and the relay will
interrupt all solenoid control and boost will default to spring pressure. .
Default setting is 13 AFR.
3. Valet ON/OFF –
When configured from the gauge, this setting is
accessed from the main screen. Press and HOLD both the left and right
interface buttons, this will disable/enable relay control. When Valet mode
is active, the relay will interrupt all solenoid control and boost will default
to spring pressure. If there are no other error codes on the status
viewport of the screen, the PSB-1 will display “Valet” when active. In LM
Programmer, use the ‘Valet Mode OFF’ checkbox to turn the solenoid
control ON/OFF. Default setting is Valet mode OFF.
Logworks 3 & LM Programmer Software Package
4
The PSB-1 can be connected directly to your Windows computer to log and
analyze data with the Logworks software or to configure with LM
Programmer. The software is a free download on the Innovate Motorsports’
support section of the website.
