Page 4 of 11
Edition 07/21/2008
INNOTECH
INNOTECH LOCK
INNO
TECH
LOCK-11 /-13
INSTRUCTIONS FOR
INSTALLATION AND USE
SAFETY INSTRUCTIONS
•
Fastening on the INNOTECH LOCK always occurs through the eyebolt with a carabiner and
must be used with personal protective equipment in accordance with EN 361 (safety
harness) and EN 363 (fall arrest system).
•
For horizontal use, only those fasteners may be used that are suited for this purpose and
have been tested for the respective edges (sharp edges, sheet with trapezoidal
corrugations, steel girder, concrete, etc.).
•
There is a hazard when combining individual elements of the specified units, since the safe
function of one of the elements can be impaired through the combination.
•
Before use, you must visually check the entire fall arrest system for obvious defects (e.g.
loose screws, deformations, abrasion, corrosion, etc.).
If in doubt relative to safe function of the anchorage point it must be taken out of service
and sent to the manufacturer for inspection.
•
At least once a year, an expert must check the complete safety device including the
personal protective equipment used. The inspection by an expert must be documented in
the provided test log.
•
The INNOTECH LOCK was developed for personal safety and may not be used for other
purposes. Never attach undefined loads to the restraint system.
•
Do not make any changes to the enabled anchorage device.
•
If you provide the restraint system to external contractors, the instructions for installation
and use must be handed over in writing.
+
The concrete must be in perfect condition and without noticeable flaws.
+
If possible do not work above the anchorage point.
(See the instruction manual for the rope)
+
After a fall, stop using the product and have it checked by the manufacturer.
+
Do not allow any contact between the anchorage point and chemicals or other aggressive
substances. Contact the manufacturer if in doubt.
