8
STOVE GUARD SGK500 USER MANUAL
The Intelligent Heat Sensor is powered by solar panels, using a battery for back-up power. The
working life of the Sensor is at least 15 years, but in practice will be longer, if the solar panels
receive enough light. A low battery in the Intelligent Heat Sensor causes both the Intelligent
Heat Sensor and the Control Unit to emit a signal once a minute. The battery is fixed and can-
not be changed. When the Sensor is at the end of its working life, please take care to recycle
the old Sensor appropriately.
The low battery alarm can be postponed for 12 hours by pushing the Intelligent Heat Sensor
cover once. The Control Unit will carry on emitting the battery alarm signal after the Intelligent
Heat Sensor has been removed or its battery has run out. Reset the Control Unit battery signal
by turning the electricity off and then back on using the main switch. An empty battery in the
Intelligent Heat Sensor does not affect the safety features of the Control Unit.
2. Monthly Maintenance (cont.)
3. Low battery alarm
1.
Remove the Intelligent Heat Sensor from its packaging and allow about 15 minutes
for it to reach room temperature.
2. The Intelligent Heat Sensor uses different settings for electric and gas burners. Carry out
initialization as described below, depending on hob type. If later you wish to change the hob
type setting, see ‘Changing the hob type setting’ section 7.
Electric burners:
Remove the installation plate (1, see image on next page) that covers the
bottom of the Intelligent Heat Sensor by lifting it up. Lifting up the installation plate will also
bring up the battery disconnection piece (2, see image on next page), connecting the battery.
The Intelligent Heat Sensor will emit a signal signifying that the battery is connected. Initialize
the Intelligent Heat Sensor by pressing the cover once. Save the battery disconnection piece
for possible later use..
Gas burners:
Remove the installation plate (1, see image on next page) that covers the bot-
tom of the Intelligent Heat Sensor by lifting it up. Lifting up the installation plate will also
bring up the battery disconnection piece (2, see image on next page), connecting the battery.
The Intelligent Heat Sensor will emit a signal signifying that the battery is connected. Take the
Intelligent Heat Sensor to your hand, holding it from the top and the bottom. Press the cover
towards the bottom so that the green light alights and hold it down. Whilst pressing the cover,
Ensure that all other alarms being used with the Stove Guard are cleaned and their batteries
changed according to their instructions.
4. Intelligent Heat Sensor Installation
Summary of Contents for Stove Guard SGK500
Page 22: ...19 IMAGES 2 3 1...
Page 23: ...20 IMAGES 1 4 5 6 7 1 2 1 o n o f f 1 2 on off...
