Installing the charging station - Wiring Option A
When the cabling is installed through the bottom cable inlet
DANGER: Make sure the power supply for the charging station is disconnected before installation. Do not turn
power on until electrical wiring is finished.
1. Before installation of the charging station, it is recommended that the power supply cabling is prepared first.
Note: Leave the PE wire 20 mm longer than the other wires. This will make sure that it is the last remaining
connection if the cable is pulled by excessive force.
Recommended stripping length for wiring option A: 3-phase power supply
Recommended stripping length for wiring option A: 1-phase power supply
Recommended stripping length for wiring option A: 1-phase power supply for IT power grid
2. A rubber grommet is used to prevent dust and moisture entering the charging station. To prepare the grommet, make a
small cross shaped cut where the power cable enters the grommet.
9
