HomePlug AV Wireless-N 210P-I1
The Description of each labeled part is described in the table below:
WLAN LED
Lit green when the wireless function is enabled.
Blink when data is transmitted or received via WLAN.
Blink quickly when WPS is activated.
Power LED
Lit when the power is on.
PLC
(Powerline Link/Act)
LED
Lit when the powerline sync is established.
Blink after Sync button is pushed (see Sync button description below)
Blink quickly when data is transmitted or received via powerline.
ETH
(Ethernet Link/Act)
LED
Lit when connected to an Ethernet device.
Blink when data is transmitted or received via Ethernet port.
WPS Button
Push this button to trigger Wi-Fi Protected Setup function.
Sync Button
Used to establish a LAN network with other powerline devices.
Press this button for
1~3 second(s)
and release it to set device into
powerline Sync state.
Reset Button
Press this button for
1~3 second(s)
to reset the device to factory
default settings.
Ethernet Port
Connect the HomePlug AV device with an Ethernet device (e.g.
computer, router, hub/switch, IP pone, IPTV set-top-box, gaming
consoles), using the RJ-45 Ethernet cable included.
Power Plug
Plug into an AC outlet for power supply and to build a powerline
network with other HomePlug AV devices.
Clip Socket
Install the clip into this socket.
Note: Please DO NOT remove or disassemble the socket clip
frequently as this may cause serious damage on your HomePlug
AV device.
10
