8520-C1 User Manual
21
To configure the WAN IP settings:
Select/Unselect to enable or disable the Access Configurator option. In case, you
enable the access configurator, enter the value in Access Concentrator.
Select one of the following options:
z
Obtain an IP address automatically.
z
Use the following IP address: specify the WAN IP Address.
Click to Enable NAT.
Click to Add Default Route
Click Next.
Configuring the Broadband User Name and Password
Figure 18 : Configuring Broadband User Name and Password
To configure the broadband user name and password:
Enter the Service Name like ISP1-PPPoE etc.
Enter the user name in
Broadband User Name
.
Enter the password in
Password
and confirm it by entering again in
Confirm
Password
.
Select the authentication mode (none, auto, chap, pap)
Specify the network session by selecting
Always On
,
Dial on Demand
or
Manually Connect
option. You could check the
Consider LAN side Traffic Only
to
specify the data traffic for
Dial on Demand
and
Manually Connect
. You can also
opt to disconnect after a specified period when no user activity is detected. By
default, the option
Always On
is selected.
Click
Next
.
Summary of Contents for 8520-C1
Page 6: ...8520 C1 User Manual VI 18 Appendix G Regulation 87 19 Appendix H Contact Information 90...
Page 59: ...8520 C1 User Manual 53 Advanced Figure 58 View Advanced Raw Ethernet Port Parameters...
Page 61: ...8520 C1 User Manual 55 Advanced Figure 60 View Advanced DSL Port Parameters...
Page 63: ...8520 C1 User Manual 57 Advanced Figure 62 View Advanced Wireless Port Parameters...
