18
CTL101 Operation Manual - V1.3 03/22/02
©2002 - INLINE, Inc.
INFRARED CODES
If the application involves infrared codes, type "2"in the main menu followed by ENTER. The
next series of menus will look like this:
IR Codes - enter selection.
1. Clear All codes in user programmable group.
2. Set/Change/Clear/Display a code. (ASCII format)
3. Set/Change/Clear/Display a code. (HEX format)
4. Select current code group.
5. Exit.
Select 2, or 3.
**Press remote button.
**Press again - Verify.
**New:
Enter selection.
1. Enter code.
2. Delete code.
3. Display current.
4. Exit.
Select "1".
Enter selection.
1. Remote delay ON - for Single push.
2. Remote delay OFF - for Continuous push.
Begin entering Command codes
- End with a Code End character (Default = asterisk *)
- Backspaces will be ignored.
1. Clear All Codes in User Programmable Group - allows users to erase all group #3
command codes (provided that group #3 is enabled).
The CTL101 features three groups of command codes associated with IR signals. The first
two groups are programmed at the factory with the serial command codes for INLINE video
scalers, switchers and matrices, and cannot be changed. The third group allows users to
program their own set of command strings. Once established, the unit will always power up
in the last group selected.
Group #1 Command Codes - allow users to run a single INLINE unit by using the same
delimiters (the same beginning and end [ ] brackets).
Group #2 Command Codes - have different delimiters allowing the simultaneous usage of
several pieces of INLINE equipment (i.e. switcher { }, matrix ( ), scaler [ ]).
Group #3 Command Codes - are completely user programmable and are capable of
directing several pieces of equipment simultaneously.
Note: When programming Group 3 for the first time or reprogramming the entire group, Group
3 must be enabled, and all codes must be cleared before you begin.
Summary of Contents for CTL101
Page 1: ...CTL101 CONTROL INTERFACE CTL 1 0 1 OPERATION MANUAL...
Page 4: ......
