12
CTL101 Operation Manual - V1.3 03/22/02
©2002 - INLINE, Inc.
CTL101 Connectors and Controls
FRONT PANEL INDICATORS
The Remote and Power LED’s, and the IR receiver sensor are located on the front panel of the
CTL101 (see the diagram on the following page). The Power LED will illuminate as soon as
power is applied to the unit (the CTL101 has no ON/OFF switch). The Remote LED will
illuminate whenever the interface receives an infrared signal from any IR remote control.
REAR PANEL CONNECTORS AND CONTROLS
All connectors and controls are located on the back of the unit, and the dipswitches are located on
the bottom (see the Dipswitch Bank Tables on page 14).
Sensor Mode - is located on the left rear of the CTL101. This switch allows users to toggle
between the unit’s internal IR sensor and the remote sensor. When the switch is in the INT
position (down), the unit’s internal IR sensor is active (factory default). In the EXT position
(up), the remote sensor (attached to the IR Sensor Input) is active.
IR Sensor Input - is a 4-pin captive screw terminal that connects directly to the CTL131DB /
CTL131DW IR Remote Sensor (see Application Diagram D on page 10).
Contact Closure Ports - allow users to connect up to 16 devices with contact closure capability
(see Application Diagram C on page 9).
RS-232 / RS-422 / RS-485 Serial Ports - The Output Port connects directly to the IN1402 /
IN1403 / IN1404 Video Scaler, IN3600 Series Switcher or IN31608 Matrix or any other device
that accepts ASCII command strings. The Input Port connects directly to the computer
workstation (see Application Diagram E on page 11).
IR Out - connects to the CTL130 IR Emitter via a 2-pin captive screw terminal (see Application
Diagram D on page 10).
Fuse - 0.25A, time delay
Power - Universal power: 90 - 260 VAC, 47 - 63 Hz.
Summary of Contents for CTL101
Page 1: ...CTL101 CONTROL INTERFACE CTL 1 0 1 OPERATION MANUAL...
Page 4: ......
