TILT Assembly Manual
Code No.: MD03001-00-1107
16
Step 15
Mark 490 mm span in the belt with a
marker leaving similar belt length on
both sides. Pass the open belt
through the pulleys as shown in the
picture.
Check the arms support tensors are
loose and on the bottom of their
travel range.
Install the belt clamp ‘tightening’ the
belt until the 490 mm marks are
being nearly covered by the clamp
parts. Ensure the belt teeth match the
clamp cavities.
PARTS
Same as step 14
Belt
Clamp parts A and B
HARDWARE
4x screw M2x10
4x lock nut M2
8x washer M2
